ES

FMI-S
Operation manual
Bedienungsanleitung
Notice d’utilisation
Instrucciones de servcio
Istruzioni per l’uso
www.alluris.de
Page 8 of 15
5.2 Threshold value operation mode
Force gauge series FMI-S30 can comparate the actual measured value with limit values. As
soon as the thresholds are exceeded this is indicate in the diplay and signal outputs are swit-
ched accordingly.
5.2.1 Comparator function
If a threshold value is adjusted (at least one of the limit values
is uneven 0 and the display shows the LIMIT sign) an arrow be-
side the indicated actual value points down as long the lower
limit is not exceeded. Is the actual value higher then the upper
threshold the display shows an arrow pointing up. As long as
the actual force value is between the lower and upper threshold
value, the display shows the value only (without arrows).
5.2.2 Adjust the limit values
In order to set the limits easily and in accordance to the above mentioned standards we re-
commend the use of the optional Software FMI_Connect. Nevertheless you can adjust the
limits directly after you have restarted the instrument or deleted all saved data, by pressing
the S-Button for 2 seconds until the display shows P1. Select the setting menu P3 for the upper
limit and P4 for the lower limit by pressing the I-Button and adjust the limit values.
Limit
Limit
0
>
>
0
>
>
0
>
>
0
>
>
0
>
>
0
>
>
Vorzeichen
Limit
I
+ | -
Digit 1
Limit
I
0, 1, 2, 3, 4, 5, 6, 7, 8, 9
Digit 2
Limit
Digit 3
Limit
Digit 4
Limit
Digit 5
Limit
With a short press on the S-Button you return to the main setting menu. Choose now P4 by
pressing the I-button and adjust the lower limit valus as described before.
5.2.3 Delete limit value
The limit comparator function is deactivated by setting the limits back to „0000.0“ or by re-
setting the instrument to the original works defaults by using the setting menu P0 (see also
chapter 6.7)
FMAX
50
0
50
OUT
9
8
HI LO
F
MIN