User Manual

ManualsBrandsDE-STA-CO ManualsEquipmentIM-pAC AC Drive Getting Started Guide

IM-pAC Getting Started Guide 51

Issue Number: 5 www.camcoindex.com | www.destaco.com

Read Me First

Instructions

Safety Information Rating Data

Mechanical

Installation

Electrical Installation Keypad and Display

Parameters

Diagnostics

UL Listing

Information

The setting of Pr 05 automatically sets up the drives configuration.

In all of the settings below, the status relay is set up as a drive ok relay:

Figure 7-1 Pr 05 = AI.AV

Terminal B7 open: Local voltage speed reference (A2) selected

Terminal B7 closed: Remote current speed reference (A1) selected

No Function Range Defaults Type

Drive configuration

AI.AV, AV.Pr, AI.Pr, Pr, PAd,

E.Pot, tor, Pid, HVAC

3:Pr RW

A change to Pr 05 is set by pressing the MODE key on exit from parameter edit mode.

The drive must be disabled, stopped or tripped for a change to take place. If Pr 05 is

changed while the drive is running, when the MODE key is pressed on exit from

parameter edit mode, Pr 05 will change back to its previous value.

NOTE

When the setting of Pr 05 is changed, the appropriate drive configuration parameters are

set back to their defaut values.

NOTE

Configuration Description

AI.AV Voltage and current input

AV.Pr Voltage input and 3 preset speeds

AI.Pr Current input and 3 preset speeds

Pr 4 preset speeds

PAd Keypad control

E.Pot Electronic motorized potentiometer control

tor Torque control operation

Pid PID control

HUAC Fan and pump control

OK Fault

Remote current speed

reference input (A1)

+10V reference output

Local voltage speed

reference input (A2)

+24V output

Drive Enable/Reset

Run Forward

Run Reverse

Local (A2)/Remote (A1)

speed reference select

Remote speed

reference input

10k

(2kmin)

+24V

Eur