User Manual

IM-pAC Getting Started Guide 49

Issue Number: 5 www.camcoindex.com | www.destaco.com

Read Me First

Instructions

Safety Information Rating Data

Mechanical

Installation

Electrical Installation

Keypad and Display

Parameters Diagnostics

UL Listing

Information

6.6.1 Setting a security code

•Set Pr 10 to L2.

•Set Pr 25 to the desired security code e.g. 5

•Set Pr 10 to LoC.

• Press the MODE key

•Pr 10 will now be reset to L1 and Pr 25 will be reset to 0.

• The security code will now be locked into the drive.

• Security will also be set if the drive is powered down after a security code has been

set into Pr 25.

6.6.2 Unlocking a security code

• Select parameter to be edited

• Press the MODE key, the right hand display will flash 'CodE'

• Press the UP key to start entering the set security code. The left hand display

will show 'Co'

• Enter the correct security code

• Press the MODE key

• If the correct security code has been entered, the right hand display will flash and

can now be adjusted.

• If the security code has been entered incorrectly, the left hand display will flash the

parameter number. The above procedure should be followed again.

6.6.3 Re-locking security

When a security code has been unlocked and the required parameter changes made, to

re-lock the same security code:

•Set Pr 10 to LoC

• Press the MODE key

6.6.4 Setting security back to 0 (zero) - no security

•Set Pr 10 to L2

• Go to Pr 25

• Unlock security as described above.

•Set Pr 25 to 0

• Press the MODE key.