User Manual

12 IM-pAC Getting Started Guide
www.camcoindex.com | www.destaco.com Issue Number: 5
1.18 Drive parameter list for using a potentiometer to control
speed
Pr 37
Maximum switching
frequency
12 kHz
Pr 38 Auto-tune 0
Pr 39 Motor rated frequency 60 Hz (from motor plate)
Pr 40 Number of motor poles 2:4 pole
Pr 41 Voltage mode select 2:Fd
Pr 42
Low frequency voltage
boost
4
Pr 43 Serial comms baud rate 19.2
Pr 44 Serial comms address 1
Pr 45 Software version 1.04
Pr 46
Brake release current
threshold
50
Pr 47
Brake apply current
threshold
10
Pr 48 Brake release frequency 1 Hz
Pr 49 Brake apply frequency 2 Hz
Pr 50 Pre-brake release delay 0 s
Pr 51 Post brake release delay 0 s
Parameter Description Value Units
The speed range of the potentiometer is from 0 to the Pr 02 value.
NOTE
Parameter Description Value Units
Pr 01 Minimum set speed 0 Hz
Pr 02 Maximum set speed 60 Hz
Pr 03 Acceleration rate 1 0.1 s/100Hz
Pr 04 Deceleration rate 1 0.2 s/100Hz
Pr 05 Drive configuration 1:Av.Pr
Pr 06 Motor rated current - A (from motor plate)
Pr 07 Motor rated full load rpm 0 RPM (always 0)
Pr 08 Motor rated voltage - V (from motor plate)
Pr 09 Motor rated power factor - (from motor plate)
Pr 10 Security status 0:L1
Pr 11 Start / stop logic select 0
Pr 12 Brake controller enable 0:dis
Pr 15 Jog reference 1.5 Hz
Pr 16
Analog input 1 mode
(terminal T2)
6:VoLt
Pr 17
Allow negative
references
OFF
Pr 18 Preset speed 1 0 Hz
Pr 19 Preset speed 2 0 Hz
Pr 20 Preset speed 3 0 Hz
Pr 21 Preset speed 4 0 Hz
Pr 22 Load display units Ld