Instruction Manual

5
Description/Use
en
fective outlets must be replaced before using the
heater. Plugging the heater into a worn outlet
may result in overheating of the power cord or
may cause the risk of re.
- If the power cord is damaged, to reduce the risk
of malfunction it must be replaced by the ma-
nufacturer, its service agent, or a licensed and
qualied professional.
- Do not use this appliance with an extension cord
or outlet strip. Connect the appliance directly to
a suitable outlet.
- Make sure that the plug is fully inserted into
the outlet. Wall outlets may deteriorate with
time, so check the plug periodically for signs of
overheating or deformation. If the outlet has de-
teriorated, stop using it and have it repaired.
- Check that neither the appliance nor the power
cord have been damaged during shipping.
- Make sure that no styrofoam or other packing
materials remain in the appliance.
- Make sure that no pieces of polystyrene or other
packaging material have been left between one
element of the appliance and another.
It may be necessary to pass over the appliance
with a vacuum cleaner.
- The rst time the appliance is used, run it at the
maximum power for at least two hours. During
this time, ventilate the room thoroughly to eli-
minate the “new” smell released by the applian-
ce. It is completely normal for the appliance to
emit “creaking” sounds the rst time it is run.
- CAUTION: To prevent electric shock, make sure
the wide prong of the plug is inserted in the wide
slot of the outlet.
- Do not place the heater near a bed because
objects such as pillows or blankets can fall o
the bed and be ignited by the heater.
- Extreme caution is necessary whenever the hea-
ter is left operating unattended.
- Do not open the appliance. No user-serviceable
parts inside.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY
DESCRIPTION
A Display
B On-o button
C Power setting button
D + Adjustment button
E - Adjustment button
F
Timer button
G Brightness button
H Eco button
I Cord holder
L Wheel
USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in
order to prevent damaging the paint nish.
Fully unfold the wheels by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface area
of less than 43 square feet (4 sq.m.).
Power connection
The radiator must be connected to a properly polarized A/C
110/120 V household outlet in perfect working condition.
The appliance will be set in the o condition.
The display will show the
symbol. Keep loose clothing
or bedding, furniture and ammable material away from
the power outlet where the heater is plugged in. After an
interruption of the power supply (power failure or appliance
unplugged) the unit goes always to o.
When the unit is switched on by pressing the on-o button,
the operating conditions will be same ones previously set.
Fig. 1