Operation Manual
52
De Dietrich Gas 310/610 ECO
13.0 SETTING MODE
13.1 User level setting mode ()
Setting mode is used to change various settings to suit individual requirements. The required code is selected by
pressing the
key until appears in the code window. Select the required code with the key. Now press
the [+] key to increase a setting or the [-] key to decrease a setting.
Press the
key to stare the new setting. The new value will flash twice in the window to confirm the setting.
Cede
Description
Setting range and explanation if
necessary
Factory setting
Flow temperature set point (see
section 13.1.1)
- = 68 – 194°F or
- [20-90°C]
Boiler operating limit set point, also maximum
setting if external control is used.
= 176°F
= 80°C
Pump post
purge setting
(see section 13.1.2)
= Pump post purge = 10 seconds
- = pump run on in minutes
= Pump operates continuously
Boiler control
setting
(see section 13.1.3)
Control mode (modulating, on/off, etc.)
Important!! Changing and should only be 0n design engineer’s advice.
13.1.1 Flow temperature ()
The required flow temperature is adjustable from 68-194°F [20-90°C].
The following diagram shows a typical example of this procedure:
Table 17 Settings mode user level
Fig. 26 Setting flow temperature