Specifications

7 x 9 inches (178 mm x 229 mm)
Medtronic Confidential
Refer to the “Reference man.” category in doc#163256 for Printing
Instructions.
196407001 Rev A
Programming the Pacemaker Serial Number
Serial number programming should not be used to change the factory
setting. This procedure is intended only for reprogramming the original
serial number in the unlikely event it is lost from pacemaker memory due to
a pacemaker electrical reset (see previous section about programming the
Reset command).
To reprogram pacemaker serial number:
1. Select
Serial Number
from the list of parameters on the Additional
Parameters screen.
2. Using the on-screen keypad, enter each digit of the original serial
number. The selected numbers will appear in the small window to the
right of the keypad.
3. If you make a mistake, select [
CLEAR VALUE
]. Otherwise, select
[
ACCEPT VALUE
] to register the entered number as a pending value.
4. Position the programming head and select [
PROGRAM
]. Hold the pro-
gramming head steady until you receive a programming confirmation.
6-10 Using the Programmer