Specifications

7 x 9 inches (178 mm x 229 mm)
Medtronic Confidential
Refer to the “Reference man.” category in doc#163256 for Printing
Instructions.
196407001 Rev A
Selecting the Pacemaker Model
The procedure for starting a patient session begins at the Automatic Model
Select screen shown in the example below. This screen appears after you
turn the programmer on as described in the previous section (or after you
select the [
END SESSION
] button to end a patient session).
To start a patient session, you must select the appropriate pacemaker model.
NOTE: When you end a patient session, the Data Transfer to Disk window
may be superimposed on the Automatic Model Select screen. If you do not
wish to use the Data Transfer feature, select [
CANCEL
] to close the window
(see CAUTION below).
CAUTION: Selecting a pacemaker model or turning the programmer off
will automatically clear all data reports accumulated in memory during the
previous patient session.
If you wish to print these reports, refer to “Printing Reports After a
Session Has Ended” on page 2-13.
If you wish to transfer these reports to a computer diskette, refer to
“Transferring Session Data to a Diskette” on page 2-13.
Automatic Model
Select Screen
With the programming
head in position, select
this button for auto-
matic model selection.
For manual model
selection, select proper
button to display model
options.
3-4 Using the Programmer