Specifications

7 x 9 inches (178 mm x 229 mm)
Medtronic Confidential
Refer to the “Reference man.” category in doc#163256 for Printing
Instructions.
196407001 Rev A
Programming Emergency Parameters
The Emergency programming command is a safety feature that overrides
all other functions and immediately programs the pacemaker to preset
emergency values intended to provide pacing support under a variety of
conditions. This programming cancels any temporary function in effect and
restores magnet mode operation.
Emergency values are permanent settings that provide higher-than-normal
energy output. It is not intended that the pacemaker be left at these settings.
Emergency Values
Pacing Mode VVI
Rate 70 ppm
V. Refractory Period 330 ms
V. Pulse Amplitude 7.5 V
V. Pulse Width 1.5 ms
V. Sensitivity 2.8 mV
V. Pace Polarity Unipolar
V. Sense Polarity Unipolar
Single Chamber Hysteresis OFF
The [
EMERGENCY
] button appears in the lower left corner of all function
screens.*
To program Emergency parameters:
1. Position the programming head over the pacemaker.
2. Select the [
EMERGENCY
] button.*
3. Hold the programming head steady until a confirmation message
appears. If programming is not confirmed, verify that the programming
head is properly positioned and then reselect [
EMERGENCY
].
*If you are using a 9790 programmer, you can press the square red button on the left side of
the display panel as an alternative to the on-screen [
EMERGENCY
] button.
Emergency Button
Ï
2-6 Using the Programmer