User guide

UC864-E/G/WD/WDU Hardware User Guide
1vv0300766a Rev.4
- 03/02/09
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 67 of 78
12.3. Mounting UC864 on your board
12.3.1. Mounting UC864-E on the Board
The position of the Molex board-to-board connector and pin 1 are shown in the
following picture.
NOTE:
The Metal taps present on UC864-E must be to GND
This module could not be processed with a reflow