User guide

UC864-E/G/WD/WDU Hardware User Guide
1vv0300766a Rev.4
- 03/02/09
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 21 of 78
For example:
1- Let us assume you need to drive the RESET# pad with a totem pole output of a
+1.8/5 V microcontroller (uP_OUT2):
NOTE:
Do not use any pull up resistor on the RESET# line or any totem pole digital output.
Using pull up resistor may bring to latch up problems on the UC864-E/G/WD/WDU
power regulator and improper functioning of the module. The line RESET# must be
connected only in open collector configuration.
TIP:
The unconditional hardware Restart must always be implemented on the boards and
the software must use it as an emergency exit procedure.