Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

&P - Default Reset Full Profile Designation

Note: if parameter is omitted, the command has the same behaviour as

AT&P0

Reference Telit Specifications

3.5.3.1.6. Store Current Configuration - &W

&W - Store Current Configuration

AT&W[<n>] Execution command stores on profile <n> the complete configuration of the

device.

Parameter:

<n>

0..1 - profile

Note: if parameter is omitted, the command has the same behaviour of

AT&W0.

3.5.3.1.7. Store Telephone Number In The Module Internal Phonebook - &Z

&Z - Store Telephone Number In The Wireless Module Internal Phonebook

AT&Z<n>=<nr> Execution command stores in the record <n> the telephone number <nr>.

The records cannot be overwritten, they must be cleared before rewriting.

Parameters:

<n> - phonebook record

<nr> - telephone number (string type)

Note: the wireless module has a built in non volatile memory in which 10

telephone numbers of a maximum 24 digits can be stored

Note: to delete the record <n> the command AT&Z<n>=<CR> must be

issued.

Note: the records in the module memory can be viewed with the command

&N, while the telephone number stored in the record

can be dialed by

giving the command ATDS=<

3.5.3.1.8. Display Internal Phonebook Stored Numbers - &N

&N - Display Internal Phonebook Stored Numbers

AT&N[<n>] Execution command returns the telephone number stored at the <n>

position in the internal memory.