Specifications
UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 33 of 318
3.5.2. General Configuration Commands
3.5.2.1.1. Select Interface Style - #SELINT
#SELINT - Select interface style
AT#SELINT=<v> Set command sets the AT command interface style depending on parameter
<v>.
Parameter:
<v> - AT command interface
2 - switches the AT command interface style of the product, to UC864
family
AT#SELINT? Read command reports the current interface style.
AT#SELINT=? Test command reports the available range of values for parameter <v>.
Note It’s suggested to reboot the module after every #SELINT setting.
3.5.2.1.2. Set Notification Port - #NOPT
#NOPT - Set notification port
AT#NOPT=<num> Set command sets the port output notification data (Indication data)
UC864 Family has the following 5 ports:
Telit USB Modem Port
Telit USB Diagnostic Interface Port
Telit USB Auxiliary Port
UART Data Port
UART Trace Port
Notification data will be sent to the specific port is set by #NOPT.
Each port has the capability like as below table
GND
(C102)
TD
(C103)
RD
(C104)
RTS
(C105)
CTS
(C106)
DSR
(C107)
DTR
(C108)
RI
(C125)
DCD
(C125)
USB
Modem
USB
Diagnosti
c
USB
Auxiliary
UART
DATA
UART
TRACE