Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

3.5. AT Commands References

3.5.1. Command Line General Format

3.5.1.1. Command Line Prefixes

3.5.1.1.1. Starting A Command Line - AT

AT - Starting A Command Line

AT The prefix AT, or at, is a two-character abbreviation (ATtention), always

used to start a command line to be sent from TE to TA

Reference 3GPP TS 27.007

3.5.1.1.2. Last Command Automatic Repetition - A/

A/ - Last Command Automatic Repetition

A/ If the prefix A/ or a/ is issued, the MODULE immediately executes once

again the body of the preceding command line. No editing is possible and no

termination character is necessary. A command line may be repeated

multiple times through this mechanism, if desired.

If A/ is issued before any command line has been executed, the preceding

command line is assumed to have been empty (that results in an OK result

code).

Note: this command works only at fixed IPR.

Note: the custom command #/ has been defined: it causes the last

command to be executed again too; but it doesn’t need a fixed IPR.

Reference V25ter