Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 313 of 318
#STSR - SIM Tookit Send Response
Use of icons is not supported. All icon related actions will respond with no
icon available.
AT#STSR? The read command can be used to request the currently ongoing proactive
command and the SAT state in the format
#STSR: <state>,<cmdType>
where:
<state> - SAT interface state (see #STIA)
<cmdType> - ongoing proactive command
An error message will be returned if there is no pending command.
AT#STSR=? Test command returns the range for the parameters <state> and
<cmdType>.
3.5.7.9. Jammed Detect & Report AT Commands
3.5.7.9.1. Jammed Detect & Report - #JDR
#JDR - Jammed Detect & Report
AT#JDR=
[<mode>
[,<MNPL>,
<DCMN>]]
Set command allows to control the Jammed Detect & Report feature.
The MODULE can detect if a communication Jammer is active in its range
and give indication to the user of this condition either on the serial line with
an unsolicited code or on a dedicated GPIO by rising it.
The MODULE can also report to the network the Jammed status condition,
even if normal communications are inhibited by the Jammer, by using a
unique message.
Parameters:
<mode> - behaviour mode of the Jammed Detect & Report
0 - disables Jammed Detect & Report (factory default)
1 - enables the Jammed Detect; the Jammed condition is reported on pin
GPIO2/JDR
GPIO2/JDR Low - Normal Operating Condition
GPIO2/JDR High - Jammed Condition.
2 - enables the Jammed Detect; the Jammed condition is reported with a
single unsolicited result code on serial line, in the format:
#JDR: <status>
where: