Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 306 of 318
#STIA - SIM Tookit Interface Activation
command is issued (see #STSGI) and after the SAT main menu has been
displayed on TE an AT#STSR=37,0,x command is issued to select an item in
the menu (see #STSR)
3.5.7.8.2. SIM Tookit Get Information - #STGI
#STGI - SIM Tookit Get Information
AT#STGI=
[<cmdType>]
#STGI set command is used to request the parameters of a proactive
command from the ME.
Parameter:
<cmdType> - proactive command ID according to 3GPP TS 31.114
(decimal); these are only those command types that use the AT
interface; SAT commands which are not using the AT interface
(not MMI related SAT commands, e.g. PROVIDE LOCAL
INFORMATION) are executed without sending any indication to
the user
1 - REFRESH
16 - SET UP CALL
17 - SEND SS
18 - SEND USSD
19 - SEND SHORT MESSAGE
20 - SEND DTMF
32 - PLAY TONE
33 - DISPLAY TEXT
34 - GET INKEY
35 - GET INPUT
36 - SELECT ITEM
37 - SET UP MENU
Requested command parameters are sent using an #STGI indication:
#STGI: <parameters>
where <parameters> depends upon the ongoing proactive command as
follows:
if <cmdType>=1 (REFRESH)
#STGI: <cmdType>,<refresh type>
where:
<refresh type>