Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 301 of 318
3.5.7.8. SIM Toolkit AT Commands
3.5.7.8.1. SIM Tookit Interface Activation - #STIA
#STIA - SIM Tookit Interface Activation
AT#STIA=
[<mode>
[,<timeout>]]
Set command is used to activate the SAT sending of unsolicited indications
when a proactive command is received from SIM.
Parameters:
<mode>
0 - Disable SAT. <timeout> is not required and will be ignored if given.
1 - Enable SAT without unsolicited indication #STN
2 - Enable SAT with extended unsolicited indication #STN (see #STGI). Both
GSM default alphabet and UCS2 character set are supported (factory
default).
3 - Enable SAT with reduced unsolicited indication #STN (see #STGI). Both
GSM default alphabet and UCS2 character set are supported.
18 - Enable SAT with extended unsolicited indication #STN (see #STGI).
Only GSM default alphabet is supported.
19 - Enable SAT with reduced unsolicited indication #STN (see #STGI). Only
GSM default alphabet is supported.
34 - Enable SAT with extended unsolicited indication #STN (see #STGI).
Only UCS2 character set is supported.
35 - Enable SAT with reduced unsolicited indication #STN (see #STGI). Only
UCS2 character set is supported.
Note: Default value for UC864-G AT&T (08.01.127) is 2.
<timeout> - time-out for user responses
1..255 - time-out in minutes (default 10). Any ongoing (but unanswered)
proactive command will be aborted automatically after <timeout>
minutes. In this case, the terminal response is either “ME currently
unable to process command”, or if applicable, “No response from
user”. In addition an unsolicited indication will be sent to the
external application:
#STN: <cmdTerminateValue>
where:
<cmdTerminateValue> is defined as <cmdType> + terminate
offset; the terminate offset equals 100.
Note: Default value for UC864-G AT&T (08.01.127) is 1.
Note: every time the SIM application issues a proactive command that