Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 274 of 318
#GDATAVOL - GPRS Data Volume
<sent n > - number of bytes transmitted in the last GPRS session for
<cid
n > PDP context;
<received
n > - number of bytes received in the last GPRS session for
<cid
n > PDP context;
2 - it reports the total GPRS data counter, since last reset, for the all the
set PDP contexts (i.e. all the PDP context with APN parameter set using
+CGDCONT), in the format:
#GDATAV
OL: <cid
n >,<tot n >,<sent n >,<received n >[<CR><LF>
#GDATAVOL: <cid
m >,<tot m >,<sent m >,<received m >[…]]
where:
<cid
n > - PDP context identifier
1..16 - numeric parameter which specifies a particular PDP context
definition
<tot
n > - number of bytes either received or transmitted, in every GPRS
session since last reset, for <cid
n > PDP context;
<sent
n > - number of bytes transmitted, in every GPRS session since last
reset, for <cid
n > PDP context;
<received
n > - number of bytes received, in every GPRS session since
last reset, for <cid
n > PDP context;
Note: last GPRS session counters are not saved in NVM so they are loosen
at power off.
Note: total GPRS session counters are saved on NVM.
AT#GDATAVOL=? Test command returns the range of supported values for parameter
<mode>.
Note Internal use only
3.5.7.4.20. ICMP Ping Support - #ICMP
#ICMP – ICMP Ping Support
AT#ICMP=<mode>
Set command enables/disables the ICMP Ping support.
Parameter:
<mode>
0 - disable ICMP Ping support (default)
1 - enable firewalled ICMP Ping support: the module is sending a proper
ECHO_REPLY only to a subset of IP Addresses pinging it; this subset of
IP Addresses has been previously specified through #FRWL (see)
2 - enable free ICMP Ping support; the module is sending a proper
ECHO_REPLY to every IP Address pinging it.