Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 266 of 318
#SKTCT - Socket TCP Connection Time-Out
query (if the peer was specified by name and not by address) is not counted
in this time-out.
AT#SKTCT? Read command reports the current TCP connection time-out.
AT#SKTCT=? Test command returns the allowed values for parameter <tout>.
Example AT#SKTCT=600
OK
socket first connection answer time-out has been set to 60 s.
3.5.7.4.12. Socket Parameters Save - #SKTSAV
#SKTSAV - Socket Parameters Save
AT#SKTSAV Execution command saves the actual socket parameters in the NVM of the
device.
The socket parameters to store are:
- User ID
- Password
- Packet Size
- Socket Inactivity Time-Out
- Data Sending Time-Out
- Socket Type (UDP/TCP)
- Remote Port
- Remote Address
- TCP Connection Time-Out
AT#SKTSAV=? Test command returns the OK result code.
Example AT#SKTSAV
OK
socket parameters have been saved in NVM
Note If some parameters have not been previously specified then a default value
will be stored.
3.5.7.4.13. Socket Parameters Reset - #SKTRST
#SKTRST - Socket Parameters Reset
AT#SKTRST Execution command resets the actual socket parameters in the NVM of the
device to the default ones.
The socket parameters to reset are:
- User ID
- Password
- Packet Size
- Socket Inactivity Time-Out