Specifications
UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
3.4. AT Commands Availability Table
The following table lists the AT commands set and matches the availability of every
single command versus the Telit wireless module family.
COMMAND UC864-
E
UC864-G UC864-WD
UC864-E-
DUAL
Function
Command Line General Format – Command Line Prefixes
AT
Starting A Command Line
A/
Last Command Automatic Repetition Prefix
General Configuration Commands – AT Interface Backward Compatibility
#NOPT
Set Notification Port
#SELINT
Select Interface Style
Hayes AT Commands – Generic Modem Control
&F
Set To Factory-Defined Configuration
Z
Soft Reset
+FCLASS
Select Active Service Class
&Y
Designate A Default Reset Basic Profile
&P
Designate A Default Reset Full Profile
&W
Store Current Configuration
&Z
Store Telephone Number In The Module Internal Phonebook
&N
Display Internal Phonebook Stored Numbers
+GMI
Manufacturer Identification
+GMM
Model Identification
+GMR
Revision Identification
+GCAP
Capabilities List
+GSN
Serial Number
&V
Display Current Base Configuration And Profile
&V0
Display Current Configuration And Profile
&V1
S Registers Display
&V3
Extended S Registers Display
&V2
Display Last Connection Statistics
\V
Single Line Connect Message
+GCI
Country Of Installation
%L
Line Signal Level
%Q
Line Quality
L
Speaker Loudness
M
Speaker Mode
Hayes AT Commands – DTE-Modem Interface Control
E
Command Echo
Q
Quiet Result Codes
V
Response Format
X
Extended Result Codes
I
Identification Information
&C
Data Carrier Detect (DCD) Control
&D
Data Terminal Ready (DTR) Control
\Q
Standard Flow Control
&K
Flow Control
&S
Data Set Ready (DSR) Control
\R
Ring (RI) Control
+IPR
Fixed DTE Interface Rate
+IFC
DTE-Modem Local Flow Control
+ILRR
DTE-Modem Local Rate Reporting
+ICF
DTE-Modem Character Framing
Hayes AT Commands – Call Control
D
Dial
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 25 of 318










