Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 203 of 318
#DIALMODE - Dialling Mode
2 - (voice call and data call) the following custom result codes are
received, monitoring step by step the call status:
DIALING (MO in progress)
RINGING (remote ring)
CONNECTED (remote call accepted)
RELEASED (after ATH)
DISCONNECTED (remote hang-up)
Note: The s
etting is saved in NVM and available on following reboot.
AT#DIALMODE? Read command returns current ATD dialing mode in the format:
#DIALMODE: <mode>
AT#DIALMODE=? Test command returns the range of values for parameter <mode>
3.5.7.1.46. Automatic Call - #ACAL
#ACAL - Automatic Call
AT#ACAL=
[<mode>]
Set command enables/disables the automatic call function.
Parameter:
<mode>
0 - disables the automatic call function (factory default)
1 - enables the automatic call function. If enabled (and &D2 has been
issued), the transition O
FF/ON of DTR causes an automatic call to the
first number (position 0) stored in the internal phonebook.
Note: type of call depends on the last issue of command +FCLASS.
AT#ACAL? Read command reports whether the automatic call function is currently
enabled or not, in the format:
#ACAL: <mode>
where
<mode>
0 - automatic call function disabled
1 - automatic call function from internal phonebook enabled
2 - automatic call function from “SM” phonebook enabled (by
AT#ACALEXT)
3 - automatic call function from “ME” phonebook enabled (by
AT#ACALEXT)
AT#ACAL=? Test command returns the supported range of values for parameter
<mode>.