Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 195 of 318
#CBC- Battery And Charger Status
0 - charger not connected
1 - charger connected and charging
2 - charger connected and charge completed
<BatteryVoltage> - battery voltage in millivolt: it is the real battery voltage
only if charger is not connected; if the charger is connected this value
depends on the charger voltage.
AT#CBC=? Test command returns the OK result code.
3.5.7.1.37. GPRS Auto-Attach Property - #AUTOATT
#AUTOATT - Auto-Attach Property
AT#AUTOATT=
[<auto>]
Set command enables/disables the TE GPRS auto-attach property.
Parameter:
<auto>
0 - disables GPRS auto-attach property
1 - enables GPRS auto-attach property (factory default): after the
command #AUTOATT=1 has been issued (and at every following startup)
the terminal will automatically try to attach to the GPRS service.
AT#AUTOATT? Read command reports whether the auto-attach property is currently
enabled or not, in the format:
#AUTOATT: <auto>
AT#AUTOATT=? Test command reports available values for parameter <auto>.
3.5.7.1.38. Multislot Class Control - #MSCLASS
#MSCLASS - Multislot Class Control
AT#MSCLASS=
[<class>,
<autoattach>]
Set command sets the multislot class
Parameters:
<class> - multislot class
1..12 - GPRS class (12 factory default)
<autoattach>
0 - the new multislot class is enabled only at the next detach/attach or
after a reboot.
1 - the new multislot class is enabled immediately, automatically forcing
a detach / attach procedure (only in case of GSM network registered).
AT#MSCLASS? Read command reports the current value of the multislot class in the