Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 192 of 318
#VAUX- Auxiliary Voltage Output Control
AT#VAUX=
[<n>,<stat>]
Set command enables/disables the Auxiliary Voltage pins output.
Parameters:
<n> - VAUX pin index
1 - there is currently just one VAUX pin
<stat>
0 - output off
1 - output on
2 - query current value of VAUX pin
Note: when <stat>=2 and command is successful, it returns:
#VAUX: <value>
where:
<value> - power output status
0 - output off
1 - output on
Note: the current setting is stored through
#VAUXSAV
AT#VAUX? Read command reports whether the Auxiliary Voltage pin output is currently
enabled or not, in the format:
#VAUX: <value>
AT#VAUX=? Test command reports the supported range of values for parameters <n>,
<stat>.
3.5.7.1.32. Auxiliary Voltage Output Save - #VAUXSAV
#VAUXSAV - Auxiliary Voltage Output Save
AT#VAUXSAV Execution command saves the actual state of #VAUX pin to NVM. The state
will be reload at power-up.
AT#VAUXSAV=? Test command returns the OK result code.
3.5.7.1.33. V24 Output Pins Configuration - #V24CFG
#V24CFG - V24 Output Pins Configuration
AT#V24CFG=<pin>,
<mode>
Set command sets the AT commands serial port (UART) interface output
pins mode.
Parameters:
<pin> - AT commands serial port interface hardware pin:
0 - DCD (Data Carrier Detect)