Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 160 of 318
+CMSS - Send Message From Storage
OK
Reference 3GPP TS 27.005
3.5.5.4.3. Write Message To Memory - +CMGW
+CMGW - Write Message To Memory
(PDU Mode)
AT+CMGW=
<length>
[,<stat>]
(PDU Mode)
Execution command writes in the <memw> memory storage a new
message.
Parameter:
<length> - length in bytes of the PDU to be written.
7..164
<stat> - message status.
0 - new message
1 - read message
2 - stored message not yet sent (default)
3 - stored message already sent
The device responds to the command with the prompt '>' and waits for the
specified number of bytes.
To write the message issue Ctrl-Z char (0x1A hex).
To exit without writing the message issue ESC char (0x1B hex).
If message is successfully written in the memory, then the result is sent in
the format:
+CMGW: <index>
where:
<index> - message location index in the memory <memw>.
If message storing fails for some reason, an error code is reported.
Note: care must be taken to ensure that during the command execution, no
other SIM interacting commands are issued.
(Text Mode)
AT+CMGW[=<da>
[,<toda>
[,<stat>]]]
(Text Mode)
Execution command writes in the <memw> memory storage a new
message.
Parameters:
<da> - destination address, string type represented in the currently