Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 146 of 318
+CNMI - New Message Indications To Terminal Equipment
(PDU Mode)
+CBM: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CBM:<sn>,<mid>,<dcs>,<pag>,<pags><CR><LF><data>
where:
<sn> - message serial number
<mid> - message ID
<dcs> - Data Coding Scheme
<pag> - page number
<pags> - total number of pages of the message
<data> - CBM Content of Message
 If <dcs> indicates that GSM03.38/23.038 default alphabet is
used , each character of GSM/WCDMA alphabet will be converted
into current TE character set (see +CSCS)
 If <dcs> indicates that 8-bit or UCS2 data coding scheme is used,
each 8-bit octet will be converted into two IRA character long
hexadecimal number (e.g. octet 0x2A will be converted as two
characters 0x32 0x41)
<ds> - SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE and messages are
stored
1 - the status report is sent to the DTE with the following unsolicited result
code:
(PDU Mode)
+CDS: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CDS: <fo>,<mr>,<ra>,<tora>,<scts>,<dt>,<st>
where:
<fo> - first octet of the message PDU
<mr> - message reference number
<ra> - recipient address, string type, represented in the currently
selected character set (see +CSCS)
<tora> - type of number <ra>
<scts> - arrival time of the message to the SC