Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 143 of 318
+CSAS - Save Settings
Note: If parameter is omitted the settings are saved in the non volatile
memory.
AT+CSAS=? Test command returns the possible range of values for the parameter
<profile>.
Reference 3GPP TS 27.005
3.5.5.2.7. Restore Settings - +CRES
+CRES - Restore Settings
AT+CRES
[=<profile>]
Execution command restores message service settings saved by +CSAS
command from either NVM or SIM.
Parameter:
<profile>
0 - it restores message service settings
from NVM.
1..n - it restores message service settings from SIM. The value of n
depends on the SIM and its max is 3.
Note: certain settings may not be supported by the SIM and therefore they
are always restored from NVM, regardless the value of <profile>.
Note: If parameter is omitted the command restores message service
settings from NVM.
AT+CRES=? Test command returns the possible range of values for the parameter
<profile>.
Reference 3GPP TS 27.005