Specifications

1500 1000 833 600 500 400 333 240 200 167 150 120 100 83.3 75 60 50 40 33.3 30
2 3 3.6 5 6 7.5 9 12.5 15 18 20 25 30 36 40 50 60 75 90 100
5.8 8.7 10.4 15 17 22 26 36 44 52 58 73 87 104 116 145 174 200 200 200
0.58 0.87 1.04 1.45 1.74 2.18 2.61 3.6 4.4 5.2 5.8 7.3 8.7 10 12 15 17 20 20 20
5.1 7.7 9.2 12.8 15.4 19.2 23.0 32 38 46 51 64 77 92 102 128 154 177 177 177
25 20 16.7
120 150 180
200 200 200
20 20 20
177 177 177
9PBKŪBH
9PFKŪBH
9DCPŪ-90-30
speed RPM (r/min)
Gear Ratio
Model
Motor/Gearhead
kgf cm
N.m
lb-in
Ū
90mm(3.54in.)
DC MOTOR
90W
ū Motor Specification
9DCP(D)12-90-30
9DCP(D)24-90-30
9DCP(D)90-90-30
1/8 90 2900 290 41.13
12 2.0 3450 10.0 3000
24 0.9 3050 5.0 3000
90 0.3 3200 1.4 2800
60 20000 2000 284
40 25000 2500 355
15 32000 3200 454
gfcm mN.m oz-ingfcm mN.m oz-in
Torque
Starting Torque
Model
9DCPŪ-90-30 : Pinion Shaft Type
9DCDŪ-90-30 : D-Cut Shaft Type
Output
No Load Rated Load
HP
W
*ĸPinion ShaftĹis for attaching gearhead and ĸD-Cut ShaftĹis for using motor only.
ū Permissible Torque When using gearhead
ҊEnter the phase & voltage code in the box (Ū) within the motor model name.
ҊEnter the gear ratio in the box (Ū) within the gearhead model name. A colored background indicates gear shaft rotation in the same direction
as the motor shaft ; a white background indicates rotation in the opposite direction.
ҊThe speed is calculated by dividing the motorĹs synchronous speed (50Hz : 1500 r/min, 60 Hz : 1800 r/min) by the gear ratio.
ҊThe actual speed is 2~20% less than the displayed value, depending on the size of the load.
ҊIf more slow speed is needed than above value, use decimal gearhead with a gear ratio of 10:1 could be used between general gearhead and
motor. Even in this case, just speed will be reduced without increase in permissible torque; the maximum permissible torque is 200kgfcm
(20N.m, 177lb-in).
ū Dimension
1. Worm Solid Gearhead Type
Rated V
Starting Cur.
A
Speed
RPM
Current
A
Speed
RPM
Current
A
VDC
DC 90W