Specifications

CAUTION FOR USING
Before using, make sure to use it after reading the Instruction Manual closely.
For the suggestions on using, they are classified as caution and warning
ҕUse only according to the specifiation of speed controller. If not, there will be dangerous fire, electric shock, iniury and
damage of the unit.
ҕDo not put the fingers or things into the outlet of the unit. There may be the electric shock, injury or danger of fire.
ҕDo not operate with the wet hands. The electric shock may occur.
ҕIn case of moving, do not catch the output shaft, connecting part or the lead wire.There may be the injury by the drop.
ҕMake sure to check whether the things are what you ordered. If you install the other thing, there may occur the injury
and the fire.
ҕThe motor should be used after it is fixed tightly. If not, there may occur the injury and the damage of the unit.
ҕMake sure to install the cover not to touch the rotatory part. If not, there will be injury.
ҕMake sure to check the rotatory direction before connecting the machine. If not, there may occur the injury and the
damage of the unit.
ҕDo not touch the side of the motor output shaft (key way. cutting part) with the naked hands. If not, there may occur
the injury.
ҕMake sure to install the overload device, for the protection device is not attached to the motor.
It is desirable to install the promotion device leakage shorter electricity except the overload protection device.
If not, the fire may occur.
ҕIn case of putting out power plug, do not draw with grasping the plug for the electric shock and fire may occur.
ҕThe motor and the controlling unit should be used only by the designated compounding. If not, the fire may occur.
ҕBefore connecting with the machine and beginning to operate, make sure to install the parameter for the machine.
If not, the damage may take place.
ҕIn case of connecting with the machine and beginning to operate, do in the state of emergency stop anytime.
If not, the damage will occur.
ҕIf there are abnormal cases, turn off the power at once. If not, there will be the electric shock, injury and the damage.
ҕIn operating do not touch the rotor(output shaft). If not, the damage will take place because of winding.
ҕIn operating and right after the operation, do not touch the controlling device by your hands or body. The fire will occur.
ҕNever put around the explosive atmosphere, gas to be burnt, corrosive air, the location to be wet and combustibles.
If not, there may occur the electric shock and the fire.
ҕIn case of movement, connection and checking of motor, please turn off the electric power.
ҕMake sure to connect motor and speed controller based on the specification. If not, there may occur the electric shock
and the fire.
ҕThe power cable and the lead line should not be bent, pulled and inserted by force. If not, the electric shock and the
fire may occur.
ҕIn case the motor and controlling unit are attached to the machine, never touch by hand or connect with the earth. If
not, the electric shock may take place.
ҕNever operate in the state of exposing the flowing current. If not, the electric shock may take place.
ҕIn case of interruption of electric power and wiring the protection of overheat, please turn off the power. When motors
are working continuously, there may be injury and damage of the unti.
ҕWithin the 30 seconds after the power off, do not touch the output terminal of the controlling unit. If not, the electric
shock may occur because of the residual volts.
CAUTION
WARNING