THE PROFESSIONAL WARMING DRAWER Installation Guide Models: ■ WD-27SS ■ WD-27BK ■ WD-27WT ■ WD-27GN ■ WD-27BL ■ WD-27PL ■ WD-30SS ■ WD-30BK ■ WD-30WT ■ WD-30GN ■ WD-30BL ■ WD-30PL
A Message To Our Customers Thank you for selecting this DCS Warming Drawer. Because of its unique features, we have developed this Installation Guide. It contains valuable information on how to properly install your new Warming Drawer for years of safe and enjoyable use.
Table Of Contents SAFETY PRACTICES & PRECAUTIONS ...........................................................................3-4 INSTALLATION INSTRUCTIONS ..........................................................................................5-7 Specifications ....................................................................................................................................5 Mounting Installation.............................................................................................
Safety Practices & Precautions READ AND UNDERSTAND THESE PRECAUTIONS • Read this Installation Guide thoroughly before installation. This will help to reduce the risk of fire, electric shock, or injury to persons. • Remove all packaging materials from your appliance. • Install according to instructions. See page 5-9 to insure proper installation and servicing. • Be sure to have a qualified service technician install and ground this appliance.
Safety Practices & Precautions • As with any cooking or heating appliance, never leave the warming drawer unattended when warming food, this could be a fire hazard. • Only certain types of glass, heat proof glass-ceramic, ceramic, earthenware or glazes are suitable for use in this warming drawer. Utensils that are not thermally heat safe may break with sudden temperature changes. • Never heat unopened containers, a build up of pressure may cause the container to burst.
Installation Instructions SPECIFICATIONS The cabinet depth from the outer edge of the face frame to the inside back of the cabinet or wall should be at least 23 7/8 inches (see figure 01). The Warming Drawer should be installed into a base cabinet with minimum outside dimensions of 13 1/4” high by 30” wide by 24” deep for 30” models. For 27” models 13 1/4” high by 27” wide by 24” deep (see figure 02). CUTOUT DIMENSIONS FIG.01 CUTOUT DIMENSIONS A B C WD-27 11 3/4” 25 3/8” 23 7/8” (min.
Installation Instructions MOUNTING INSTALLATION The lower rear corners of the cabinet need to provide proper support to the back of the Warming Drawer and the anti-tip mounting clips. A 120 volt AC outlet should be located no further than 36 inches from the back center of the Warming Drawer. Illustrations suggest one possible bottom support, but the consumer is not limited to this idea for mounting configuration.
Installation Instructions FIG.05 STEP 3 Center line to Center line for mounting clips WD30 - 24 1/4" WD27 - 21 1/4" FIG.
8 STRAIN RELIEF NEU L1 1 1 GND THERMOSTAT TEMP. SWITCH 2 AUX. SWITCH 2 4 3 1 LIGHT 2 WARMING ELEMENT 500 WATTS, 120 VAC.
Service HOW TO OBTAIN SERVICE: Before you call for service: 1) Is the circuit breaker tripped or the fuse blown? 2) Is there a power outage in the area? For warranty service, contact DCS Customer Service at (888) 281-5698. Before you call, please have the following information ready: • Model Number • Serial Number • Date of installation • A brief description of the problem Your satisfaction is of the utmost importance to us.
Warranty LENGTH OF WARRANTY One (1) Year Full parts and Labor Covers the entire product DCS WILL PAY FOR All repair labor and parts found to be defective due to materials or workmanship for one full year “IN HOME” warranty during the first year of ownership. This does not apply if the unit was subjected to other than normal household use. Service must be provided by Authorized Factory Agent during normal working hours.
