User guide

INSTALLATION INSTRUCTIONS

MOUNTING INSTALLATION

The lower rear corners of the cabinet need to provide proper support to the back of the Warming Drawer and the

anti-tip mounting clips. A 120 volt AC 15 amp (GFI) outlet should be located no further than 36 inches from the

back center of the Warming Drawer. Illustrations suggest one possible bottom support, but the consumer is not

limited to this idea for mounting configuration.

STEP 1

The bottom rear section of the cabinet should be made of moisture protected lumber and needs to be installed

to hold the anti-tip mounting clips and support the weight of Warming Drawer, which is 90 lbs. A pair of supports

located as shown on the previous pages is recommended to allow water to drain from drawer once installed.

STEP 2

Use the screws provided to attach the mounting clips which must be installed for anti-tip safety to the bottom

support at the back. See placement dimensions in Fig. 05 and Fig. 06.

STEP 3

The Warming Drawer has slots on the back side where it will slide onto the anti-tip mounting clips.

Plug power cord into the AC outlet. See figure 06.

STEP 4

Fasten the front face to the cabinet by passing the screws through the 2 holes of the front face of the warming

drawer to finish the installation. See figure 07.

NOTE: The bottom support made of moisture protected lumbar runners or other moisture pro-

tected construction must be capable of supporting the weight of the warming drawer. A drain hole

MUST be provided for drainage.

Slide drawer

on to Anti-Tip

mounting clips

21 3/8" (proud installation) or 23 3/8" (ush installation).

Center line

to Center line

for mounting clips

21 1/8" (536mm)

Fig. 05