Specifications

ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS
STEP 7: ANTra-TIP DEVmCE[NSTALLATION
AH ranges must have an anti-tip device correctly installed as per these instructions. If you pun the
range out from the wan for any reason, make sure that the device is properBy engaged when you
push the range back against the waN. If it is not, there is a possibBe risk of the range tipping over
and causing injury if you or a cMd stand, sit or Bean on an open door.
INCLUDED PARTS:
hduded with this kit are:
(4) #10 x 2" wood screws,
(1) Anti-tip bracket, and (1)
HnstaHHationInstructions.
INSTALLING THE KIT:
Instructions are provided
for wood and cement
floors. Any other type or
construction may require
special installation
techniques as deemed
necessary to provide
adequate fastening of the
Anti-tip bracket to the floor
and wall. The use of this
bracket does not preclude
tipping of the range when
not properly installed.
WOOD
CONSTRUCTION:
Place the bracket against
(2) Wood Screws
into Back Wall (ALL
Installations)
(2)Small Holes for
Wood Installations
(2) Large Holes for
Concrete Installations
BACK
WALL
FIG. 13
the back wail, into the right rear corner where the range is to be located. Leave a gap between the wail
(or side of range) and the bracket of 3/4'_ Drill (2) 1/8" diameter pilot holes in the center of the small
holes. A mail or awl may be used if a drill is not available. Fasten the bracket securely to the floor and
wail See Fig. 13.
CONCRETE OR CEMENT CONSTRUCTION:
HARDWARE REQUIRED: (2) sleeve anchors, lag bolts,
and washers (not provided). Locate the bracket as
described above. Drill the recommended size holes
for the hardware. Install the sleeve anchors into the
holes and then install the lag bolts through the
bracket. The bolts must be properly tightened as
recommended for the hardware. Fasten the bracket
securely to the floor and wall.
_ WARNING
ALL RANGES CAN TIP
INJURY COULD RESULT
INSTALL ANTI=TIP
BRACRET PACRED
INSIDE OVEN
® SEE INSTRUCTIONS
ONCE mNSTALLED:
Complete the range installation per the instructions provided with the product. Check for proper
installation of the Range and Anti-tip device by grasping the back of the unit and carefully attempt to
tilt the range forward.
11