Installation manual

www.mainelectronics.com
How to get system to dial your cell phone (Not tested yet)
ENTER * 8 5555 302 PHONENUMBER * 5 5 5 * # (where 5555 is the master installer code)
PRESS 310 1234 # (where 1234 is your user code)
PRESS 320 11 12 13 14 15 16 17 18 #
PRESS 350 05 05 # (not sure if you need a # here)
PRESS 351 1 2 ##
Hardware Reset (Default) Main Control Panel (just in case you mess it up)
Perform the following to default the main control panel to its original programming:
1. Power down the system completely. (Disconnect battery and AC power)
2. Remove all wires from Zone 1 and PGM1. (Please note which wires go where so you can
put them back later. ) Connect a short between Zone 1 and PGM1 on the control panel .
3. Power up the control panel (AC power only) for 10 full seconds.
4. Power down the control panel, remove short between Zone 1 and PGM1. (Put wires back
where they came from)
5. Power up the control panel.
6. Don't forget to plug the battery back in.
The above will not work if your panel was locked out by an installer.