Installation guide

5.2 Programming Worksheets
33
[013] First System Options
[014] Second System Options
[015] Third System Options
Programming option indicated in GRAY are required for systems compliant with EN50131-1 and TS50131-3 standards
[016] Fourth System Options
Opt Def ON OFF
1
J
Normally Closed Loops
9
J
End-of-line Resistors
2
J
Double End-of-line Resistors
9
J
Single End-of-line Resistors
3
9
J
Panel shows all Troubles when armed
J
Panel shows only Fire Troubles when armed
4
J
Tampers/Faults do not show as open
9
J
Tampers/Faults show as open
5
9
J
Auto Arm Schedule in [*][6] and installers
J
Auto-arm Schedule in Installer Programming Only
6
9
J
Audible Exit Fault Enabled
J
Audible Exit Fault Disabled
7
9
J
Event Buffer Follows Swinger Shutdown
J
Event Buffer Logs Events past Shutdown
8
J
Temporal Three Fire Signal Enabled
9
J
Standard Pulsed Fire Signal
Opt Def ON OFF
1
J
Arm /Disarm Bell Squawk Enabled
9
J
Arm /Disarm Bell Squawk Disabled
2
J
Bell Squawk During Auto-arm
9
J
No Bell Squawk During Auto-arm
3
J
Bell Squawk On Exit Delay
9
J
No Bell Squawk On Exit Delay
4
J
Bell Squawk On Entry Delay
9
J
No Bell Squawk On Entry Delay
5
J
Bell Squawk On Trouble
9
J
No Bell Squawk On Trouble
6
9
J
Audible Exit with Urgency
J
Silent Exit Delay
7
J
Exit Delay Termination Enabled
9
J
Exit Delay Termination Disabled
8
J
Residential Fire Bell is Continuous
9
J
Residential Fire Bell is Cut-off
Opt Def ON OFF
1
9
J
Fire Key Enabled
J
Fire Key Disabled
2
J
Panic Key Audible (Bell / Beeps)
9
J
Panic Key Silent
3
J
Quick Exit Enabled
9
J
Quick Exit Disabled
4
9
J
Quick Arming Enabled (No Code Required)
J
Quick Arming Disabled (Code Required)
5
9
J
Code Required for Bypassing
9
J
NO Code Required for Bypassing
6
J
Master Code NOT Changeable
9
J
Master Code Changeable
7
9
J
TLM Enabled
J
TLM Disabled
8
J
TLM Audible (Bell) when Armed
9
J
TLM Trouble Beeps when Armed
Opt Def ON OFF
1
9
J
AC Trouble Displayed
J
AC Trouble NOT Displayed
2
J
Trouble Light Flashes if AC Fails
9
J
Trouble Light does NOT follow AC Status
3
9
J
Blank Keypad when Not Used
9
J
Keypad Blanking Disabled
4
J
Code required to remove Keypad Blanking
9
J
No Code Required
5
9
J
Keypad Backlighting is Enabled
J
Keypad Backlighting is Disabled
6
J
Power Save Mode Enabled
9
J
Power Save Mode Disabled
7
J
Bypass Status Displayed While Armed
9
J
Bypass Status NOT Displayed While Armed
8
J
Keypad Tampers Enabled
9
J
Keypad Tampers Disabled