Installation guide

PowerSeries - PC1616/PC1832/PC1864

Section [382] Third Communicator Option Code

Section [383] Fourth Communicator Option Code

Section [389] T-Link Fault Check Timer

Programs the delay in seconds between T-Link module verification checks. Valid entries are [001]-[255].

Section [401] First Downloading Option Code

[5] ON: the system requests a Listen in/Two-way session the next time it calls the 1st/3rd Phone Number when the PC59xx transmits a

request. OFF: the system ignores the request from the PC59xx.

This Option is used with PC59xx series modules.

[6] ON: the system requests a Listen in/Two-way session the next time it calls the 2nd Phone Number when the PC59xx transmits a request.

OFF: the system will ignore the request from the PC59xx.

This Option is used with PC59xx series modules.

[7] ON: the system uses Contact ID format programmed reporting codes when transmitting reporting codes.

OFF: the system automatically generates all reporting codes transmitted.

[8] For Future Use

Option Description

[1] ON: the system will use the digit [5] as the first digit of the Partial Closing reporting code when transmitting Contact ID reporting codes.

OFF: the system will use the digit [4] as the first digit of the Partial Closing reporting code when transmitting Contact ID reporting codes.

[2] ON: the system will transmit all alarms during Walk Test. OFF: the system will not report alarm events during Walk Test.

[3] ON: the keypad will display the message ‘Communications Cancelled’ (programmable LCD) or ‘CC’ (fixed-message LCD) upon

successful transmission of the Communication Cancelled reporting event. OFF: the keypad will not display these messages.

[4] ON: the system dials the Call Waiting Cancel String on the first attempt to dial the central station. OFF: the system does not dial the Call

Waiting Cancel String.

[5] ON: enables support for the T-Link module. OFF: disables T-Link.

[6] ON: the AC Failure Transmission Delay Timer will use hours. OFF: the delay will be in minutes.

[7] ON: Sets the number of Dialing attempts to 1 when using Residential Dial Format. OFF: Residential Dial follows Dialing Attempt

Counter.

[8] For Future Use

Option Description

[1] ON: Events programmed to communicate to phone #1 will use the Partition Account Number programmed in section [311]. Events

Programmed to communicate to phone #2 will use the Partition Account Number in section [312]. OFF: Each events will use its respective

partition account code.

[2-8] For Future Use

Option Description

[1] ON: the system answers incoming calls for downloading (either Programmed Number of Rings or Double Call). OFF: the system does not

answer incoming calls for downloading.

These settings do not affect the 6 hour DLS downloading window on power up.

[2] ON: the user can enable downloading for the DLS Window using the [][6] command. OFF: the user cannot enable downloading.

[3] ON: the system will hang up after a successful DLS connection and call the computer back using the DLS Phone Number ( Section [402]).

OFF: the system stays connected to the computer.

[4] ON: the user can initiate a downloading session using the [][6] command. OFF: the user cannot initiate a downloading session.