Installation guide

Section 5 – Programming Descriptions

[016] Fourth System Option Code

Section [017] Fifth System Option Code

Section [018] Sixth System Option Code

Option Description

[1] ON: the system supervises the AC input and displays a trouble if a failure is detected. OFF: AC Input is not supervised.

[2] ON: the trouble light will flash when an AC trouble is detected. OFF: the trouble light turns on, does not flash.

[3] ON: the keypad blanks (no indicator lights) if a key is not pressed for 30 seconds. OFF: the keypad does not blank.

[4] ON: a valid user code must be entered to restore normal keypad operation after the blanking. OFF: pressing any key will return the

keypad to normal operation.

[5] ON: keypad backlighting enabled. OFF: keypad backlighting disabled.

[6] ON: the system temporarily enables the Keypad Blanking feature if an AC failure is detected (to preserve the back up battery).

OFF: the system will operate as normal.

[7] ON: the keypad turns ON the Bypass light if zones are bypassed while the system is armed. OFF: the Bypass light turns OFF when

the system is armed.

[8] ON: the system supervises keypad tampers. OFF: the system does not supervise keypad tampers.

Option Description

[1] ON: the system does NOT associate wireless keys to user codes. OFF: the system will assign user code 17 to wireless key #01,

user code 18 to wireless key #02 etc. If the wireless key is used to arm or disarm, the system will report the Opening or Closing for

the associated User Code.

[2] ON: the system logs an RF Jam trouble condition if the condition is present for 5 minutes. OFF: the system logs the trouble

condition after 30 seconds.

[3] ON: the keypads beep if an RF Jam trouble is detected. OFF: the trouble is not annunciated via the keypad buzzer.

[4] ON: the Double Hit feature will be enabled. Two violations from the same zone within the Cross Zone Timer will be considered a

valid Police Code or Cross Zone event. The system will report the event and log it to the event buffer.

OFF: two alarms from the same zone is not a valid Police Code or Cross Zone event.

[5] ON: the system logs and communicates a Late-To-Close event when it auto-arms at the programmed time (not if auto arming was

caused by the No-Activity Arming feature). OFF: the system does not transmit or log a Late-To-Close event.

[6] ON: enables the Daylight Savings automatic clock adjustment feature. OFF:

the system does not automatically adjust the clock for

Daylight Savings.

[7] For Future Use

[8] ON: the system only squawks the bell output when the system is armed in the Away mode. OFF: the system squawks the siren

when the system is armed in any mode. (See Section [14]).

Option Description

[1] ON: the system only transmits a Test Transmission reporting code if no other event was transmitted to the central station during the

programmed time. OFF the system always transmits a Test Transmission reporting code as programmed.

[2]-[4] For Future Use

[5] ON: the keypad buzzer follows the bell output for all alarms. OFF: the system only activates the bell output for all alarms.