User guide

Samsung iDCS500 DCS (Euro) Keyset User Guide
–
48
–
n
OHVA BLOCK
Your keyset can be programmed with an OHVA BLOCK key. Pressing this
key will prevent anyone from making an OHVA call to you until you press the
key again and cancel the blocking.
n
OHVA REJECT
Your keyset may be programmed with an OHVA REJECT key. Pressing this
key while receiving an OHVA call will disconnect the announcing caller and
return you to your original call. Pressing the REJECT soft key has the same
effect.
IN GROUP / OUT OF GROUP
If your keyset is assigned to a station ring group, you can remove your key-
set from the group (and re-enter it later). While you are out of the group, you
can receive calls to your extension number but not calls to the group number.
If you have an IN/OUT key programmed:
1. Press the IN/OUT key. It will light red when your keyset is in the group.
2. Press the IN/OUT key again to exit the group and turn the light off.
3. When you wish to return your extension to the group, press the IN/OUT
key again. The key LED will light red.
The IN/OUT key can include an extender to indicate the specific group that
this key will affect. This means that if you are in multiple groups, you can
decide for which groups you will receive calls.
If you do not have an IN/OUT key, check with your system administrator
whether a system access code exists for this feature and enter it here.
(IN/OUT GROUP code: )
• Dial the system access code followed by the group number, and then
dial 0 to exit the group or 1 to enter the group.
(Alternatively, press the IOG soft key in the OTHER menu, enter the group
number and then exit/enter.)
Note: If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER key before you begin dialling.