User guide

Samsung iDCS500 DCS (Euro) Keyset User Guide
–
21
–
key (or the CONF soft key) and dial your extension number. When outside
callers hang up, the lines will release automatically. To rejoin a trunk to trunk
conference, press the CONF key.
Note: Check with your system administrator whether your system is set up to al-
low this feature to work correctly.
n
CONFERENCE SPLITTING (‘L’ VERSION SYSTEMS
ONLY)
If you are controlling a conference and your keyset has the Automatic Hold
feature turned on (see the section “Customizing Your Keyset”), and all out-
side lines involved in the conference appear on keys on your keyset, you can
split the conference into separate outside calls as follows. All internal parties
will be disconnected.
• Press one of the outside line keys.
The line will remain steady green to indicate you are still connected to it. All
other outside lines in the conference will be placed on system hold at your
keyset. (All internal callers in the conference are disconnected.) You may
now speak with each caller privately—by pressing the appropriate line key—
and transfer them if necessary, or re-establish another conference.
FORWARDING CALLS
You can forward your calls to another extension, group of extensions or an
external telephone number. If you have any FWRD keys programmed, use
these to activate forwarding. A steady red light reminds you what forward
condition is activated. Otherwise, use the following procedures to set forward
conditions for your keyset.
Note:
1. Your keyset will display any forward conditions you set using the following
dial codes. You can also set and review forwarding options by programming
via the dis play (see Call Forward Options, below).
2. If your phone system is networked with another phone system, you can also
forward calls to phones in the other system (see Network Call Forwarding,
below).