User guide

SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
MMC: 404 TRUNK NAME
DESCRIPTION:
Allows a eleven (11) character name to be entered to identify an individual trunk.
Names are written using the key pad. Each press of a key will select a character. Press the desired
key to move the cursor to the next position. For example, if the directory name is “SAM SMITH,”
press the number “7” four times to get the letter “S.” Now press the number “2” twice to get the letter
“A.” Continue selecting characters from the table below to complete your message. Pressing the “A”
key will change the letter from upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as the previous character,
press the UP key to move the cursor to the right or the DOWN key to move the cursor left. A space
can be entered by using these keys.
COUNT 2 3 4 5 1
DIAL 0 Q Z . ) 0
DIAL 1 space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P R S & 7
DIAL 8 T U V
Q
8
DIAL 9 W X Y ( 9
DIAL Q : = [ ]
Q
The # key can be used for special characters: #, space, &, !, :, ?, ., %, $, -, <, >, /, =, [, ], @, ^, (, ),
_, +, {, }, |, ;, \, " and ~.
PROGRAM KEYS
UP & DOWN Used to scroll through options/move cursor left or right
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
A Key 19;acts as toggle between upper case and lower case
ACTION DISPLAY
1. Press TRSF 404
Display shows
[701] TRUNK NAME
2. Dial trunk (e.g., 705)
OR
Press UP or DOWN to select trunk and press RIGHT soft
key to move the cursor
[704] TRUNK NAME