User guide

SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
3e. Enter in desired selection from table “F” (e.g., 04)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
[257] SIM PARA.
DTR CHECK:ON
3f. Enter in desired selection from table “G” (e.g., 05)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
[257] SIM PARA.
ECHO :ON
3g. Enter in desired selection from table “H” (e.g., 06)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
[257] SIM PARA.
PROTOCOL :V110
3h. Enter in desired selection from table “I” (e.g., 07)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
[257] SIM PARA.
SPEED :9600
3i. Enter in desired selection from table “J” (e.g., 08)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
[257] SIM PARA.
CHAR LENG:8 BITS
3j. Enter in desired selection from table “K” (e.g., 09)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
[257] SIM PARA.
PARITY :NONE
3k. Enter in desired selection from table “L” (e.g., 10)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
[257] SIM PARA.
STOP BIT :1
4. Enter in desired selection from table “C”(e.g., 1)
OR
Press UP or DOWN key to make selection and press
LEFT soft key to move cursor back to step 3, and
continue entries
OR
Proceed to step 5
[257] SIM PARA.
CALL MODE:AWITH
5. Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC
TABLE A
SIM PARAMETER
00 SIM TYPE = Table B
01 CALL MODE = Table C
02 ANS MODE = Table D
03 AUTO BAUD = Table E