User guide

SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
MMC: 212 ALARM RINGING STATION
DESCRIPTION:
Used to determine which devices will be alerted when an alarm sensor is activated. The alerted
device can be as follows:
Station 201–349
Station group 500–529
The above devices will ring like a door phone and follow the door ring time-out. When ringing,
display keysets will show the display assigned in MMC 213 Alarm Message. The bottom line of
the keyset display will give an option to clear the alarm. Ringing initiated by an alarm sensor is
answered by going off-hook and on-hook again at a ringing keyset. If a device such as Ring Over
Page or a common bell is the only device assigned to ring, it may be answered by assigning a
direct pickup key with this device as the extender. If the alarm is unanswered by the door ring
time-out, ringing will cease but the display will remain until cleared by dialing the alarm clear
feature code (57) and passcode (default 8765).
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Press TRSF 212
Display shows first sensor
[3501]ALARM RING
D:500 N:500
2. Dial sensor number (e.g., 3502 )
OR
Use UP or DOWN to scroll through sensor
numbers and press RIGHTsoft key to advance
cursor
[3502]ALARM RING
D:500 N:500
3. Enter valid ring destination (e.g., 205)
OR
Press UP or DOWN key to make selection
and press RIGHT soft key to advance cursor
to night destination and press RIGHT soft key
[3502]ALARM RING
D:205 N:500
4. Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC