User guide

SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
MMC: 603 ASSIGN TRUNK GROUP
DESCRIPTION:
Allows the assignment of trunks to a specific trunk group or to several trunk groups. This is very
useful in the programming of LCR when more than one trunk is to be in several dialing plans.
There are two different modes of operation: (1) sequential and (2) distribute.
WARNING: As stated above, one trunk can appear in more than one trunk group. If necessary,
delete the trunk member from other groups to prevent accidental access.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
ANS/RLS Used to select ALL
ACTION DISPLAY
1. Press TRSF 603
Display shows
[9] TRK GROUP
MODE:SEQUENTIAL
2. Enter in valid trunk group (e.g., 9, 80–89)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
[81] TRK GROUP
MODE:SEQUENTIAL
3. Press RIGHT soft key to change mode
OR
Press UP or DOWN key to change mode to member
[81] TRK GROUP
MEMBER 01:NONE
4. Press RIGHT soft key to move cursor to number of
member and enter valid member number (1–80, e.g., 05)
via dial key pad
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor
[81] TRK GROUP
MEMBER 05:NONE
5. Enter valid trunk number (e.g., 729)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to return to step 2
[81] TRK GROUP
MEMBER 01:729
6. Repeat steps 1–6 to remove trunk from group 9 if
necessary
7. Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC