User guide

SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
`
MMC: 602 STATION GROUP NAME
DESCRIPTION:
Allows the system administrator or technician to enter a 11 character name to identify an
individual station group.
Names are written using the keypad. Each press of a key will select a character. Pressing the next
key will move the cursor to the next position. For example, if the directory name is “SAMSUNG,"
press the number “7” three times to get the letter “S.” Now press the number “2” once to get the
letter “A.” Continue selecting characters from the table below to complete your message.
Pressing the bottom left programmable key will change the letter from upper case to lower case.
NOTE: When the character that you want appears on the same dial pad key as the previous
character, press the UP key to move the cursor to the right or the DOWN key to move cursor left.
A space can be entered by using these keys.
COUNT 1 2 3 4 5
DIAL 0 Q Z . ) 0
DIAL 1 space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P R S & 7
DIAL 8 T U V
Q
8
DIAL 9 W X Y ( 9
DIAL Q : = [ ]
Q
The # key can be used for special characters: #, space, &, !, :, ?, ., %, $, -, <, >, /, =, [, ], @, ^, (, ),
_, +, {, }, |, ;, \, " and ~.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
A Key 19; acts as toggle between upper case and case
ACTION DISPLAY
1. Press TRSF 602
Display shows
[501] SGR NAME
2. Dial group number ( e.g., 505)
OR
Press UP or DOWN key to make selection and press
LEFT or RIGHT soft key to move cursor
[505] SGR NAME