User guide

SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
MMC: 508 CALL
COST
DESCRIPTION:
Allows change the system administrator to program attributes of Call Cost to be generated by the
system either on LCD during on a call or SMDR record. Attributes are listed below.
0. UNIT COST PER MP When the system is installed to receive MP on a CO outgoing call. It
is used for generating total call cost by multiplying with the number
of pulses. The MMC will allow to enter 5000 as a maximum value.
1. CALL COST RATE This will generate additional call cost calculated by multiplying this
rate to the original call cost. It ranges fro 100 through 255.
WARNING !!!
Beware of changing this value when there is a being progressed CO line
under MP detection may result in inaccurate call cost.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
ACTION DISPLAY
1. Press TRSF 508
Display shows the first item
UNIT COST PER MP
0200PENCE→
2. Dial 0 or 1
OR
Press UP or DOWN key for selection and press RIGHT
soft key to move cursor
UNIT COST PER MP
0200PENCE→
3. Enter new value (e.g., 111 for 111 percent) CALL COST RATE
100%→111
System returns to step 2
4. Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC
CALL COST RATE
111%→
DEFAULT DATA: UNIT COST PER MP 200 PENCE (UK)
CALL COST RATE 100 PRECENT