User guide

SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
TIMER NAME DEFAULT RANGE
SMDR START/DTMF 15 SEC 1–255 SEC
SYS HOLD RECALL 45 SEC 0–255 SEC
TRANSFER RECALL 15 SEC 0–255 SEC
UCDS AUDIO ALARM 0 SEC 0–990 SEC
UCDS VISUAL ALAM 0 SEC 0–990 SEC
VOICE DIAL DELAY 8 SEC 05–15 SEC
TIMER DESCRIPTIONS
AA INT DGT TIME: This timer controls the grace period between dialing valid digits before
transferring call to INVLID DEST as set in MMC 733 on a per-plan basis.
AA NO ACT TIME: If no digits are received by the AA module, this timer will expire and transfer the
call to the destination set in MMC 733 NO ACT DEST:.
ALERT TONE TIMER: This timer sets the duration of the attention tone preceding a call to a keyset in
the Voice Announce or Auto Answer mode. This tone will also precede a forced Auto Answer call.
ALM REM INTERVAL: This timer controls the time length between ring attempts at a station when
alarm reminder is set.
ALM REM RING OFF: This timer controls the length of the ring cycle duration when alarm reminder is
set at a station.
ATT RECALL TIME: This is the length of time a transfer recall will ring at a station before recalling the
operator.
AUTO REDIAL INT: This timer controls the time between attempts after RETRY dialing is set on a
station.
AUTO REDIAL RLS: This timer controls the duration of a Ring No Answer condition on a retry
number dialed before the auto redial is automatically canceled.
CALLBACK NO ANS: This timer controls the time before the callback is automatically canceled when
a callback detects Ring No Answer.
CAMP ON RECALL: This timer controls the duration of time a camped-on call will stay at a
destination before recalling to the transferring station.
CLIP DISPLAY TIME: The amount of time that the Calling Line ID information remains on the
keyset’s display.
CLIP MSG RECEIVE: The amount of time that the system will allow a valid message from the C.O.
C.O.-C.O. DISCONNECT: This timer monitors the duration of a unsupervised conference; when it
expires, both trunks are disconnected.
CONFIRM TONE TIME: The tone heard when a feature is activated or deactivated.
DIAL PASS TIME: This timer is the wait time for preventing the misdialing of an outgoing call. After
the last digit has been dialed, the voice path is connected.