Specifications

3
6. Raise the cooktop front about 6" and disconnect the 6 pin connector under the cooktop adjacent to the
left front valve.
7. Push the spark electrode wire through the holes in cooktop.
8. Pick the cooktop straight up and place in a safe area where it will not be scratched or accidently knocked
over.
9. To install the cooktop, reverse the procedure 1 through 8.
B. To Access Burner Orifices/Jets:
Unscrew the orifice using an appropriately sized conventional socket or nut driver. Use a piece of sticky tape in
socket to prevent the loose orifice from falling out.
Verify that the orifices in the kit match the chart sizes and replace the orifices.
C. To Access Valve Bypass Jets:
Remove the c-clips that retain the valve switches and slide the switches off of the valve shafts. Locate the valve
bypass jet in the valve body. Using a small 1/8" flat-blade screwdriver, carefully remove the valve bypass jets.
Replace each orifice with the marked orifice from the kit. Ensure that the replaced orifice is firmly seated in the
valve.
ORIFICE SIZES – NATURAL GAS
LOCATION MAIN SIMMER (LOW) VALVE ORIFICE (SIMMER)
SIZE MARKING RATE SIZE MARKING RATE SIZE MARKING RATE
REAR 1.51mm 151 11K Btu/hr 0.57mm P 3000 Btu/hr 0.71mm 71 1200 Btu/hr
FRONT 1.51mm 151 11K Btu/hr 0.57mm P 3000 Btu/hr 0.71mm 71 1200 Btu/hr
CENTER 2.0mm 200 17.5K Btu/hr 0.57mm P 3000 Btu/hr 0.71mm 71 1200 Btu/hr
ORIFICE SIZES – LP GAS
LOCATION MAIN SIMMER (LOW) VALVE ORIFICE (SIMMER)
SIZE MARKING RATE SIZE MARKING RATE SIZE MARKING RATE
REAR 0.89mm 89 10K Btu/hr 0.37mm G 3000 Btu/hr 0.45mm 45 1200 Btu/hr
FRONT 0.89mm 89 10K Btu/hr 0.37mm G 3000 Btu/hr 0.45mm 45 1200 Btu/hr
CENTER 1.10mm 110 15K Btu/hr 0.37mm G 3000 Btu/hr 0.45mm 45 1200 Btu/hr
Valve
Orifice
VALV E
BYPASS JET
VALVE
SWITCH
(REMOVE)
VALV E
BYPASS JET