Installation Guide

4
Remove front two screws
Open up the tank rings
Close up the tank rings and
tighten all four screws
Loosen rear two screws
STEP 6
LP Tank Restraint
IMPORTANT!
If you intend to store a 20 lb Type 1 LP Cylinder inside the cart, then the tank restraint rings on the bottom of the cart
must be used.
1 Remove the two front screws on the tank retainer rings inside the cart as shown.
2 Loosen the two rear screws (but don’t remove them)
3 Open the tank rings enough to insert the LP tank.
4 Pull the rings back around the LP tank
5 Secure all four screws.