User`s manual

3-6 Series 90™-30 CPU with Embedded PROFIBUS Interface – November 2004 GFK-2334A
3
Configuring Network Settings for PROFIBUS Master
To configure network settings for the master, double-click the Network Settings field in the
Parameter Editor Settings tab. The Master Properties dialog box opens.
Note: You can also open this dialog box by selecting the Project tab of the Navigator
and expanding the Hardware configuration folder and the rack that contains the
module. Right click the slot containing the IC693CPU366 module, and choose
Network Settings.
General Tab of the Master Properties Dialog Box
Figure 3-1. General Tab of MASTER Properties Dialog Box
Name
The name assigned to the PROFIBUS master. You can edit the name or use the default name. The
name appears in the title bar of the dialog box (in the figure above, the default name is Series 90-30
Profibus Master).
Station
The address of the PROFIBUS master on a PROFIBUS DP network. The master is configured as
Station 0 by default. Each device on a network must have a unique address.
Description
An optional user-defined description for the PROFIBUS master device, which is displayed in the
Machine Edition software’s Inspector window. The Inspector displays a maximum of 254 characters.
However, more than 254 characters can be entered in the dialog box.
Master Type
The type of PROFIBUS master device. This is a read-only field.
Device ID
The ID of the PROFIBUS master device. This is a read-only field.
Resources -
Used
The number of bytes used by the PROFIBUS master device. This is a read-only field.
Resources -
Available
The number of bytes available for use by the PROFIBUS master device. The maximum resource size
is 16384 bytes. The amount of available resources depends on the PROFIBUS slave(s) that are
configured and each slave's modules, parameters, and diagnostic messages. This is a read-only
field.