BEVERAGE CHILLER ACCESSORY BC1-25AC models USER/INSTALLATION GUIDE US CA
CONTENTS Introduction 3 Safety and warnings 4 Product dimensions 5 Cutout dimensions 6 Attach the bottle holder to unit 8 Secure product into cutout Final checklist 9 10 1
INTRODUCTION An ultimate entertainer`s feature, the 25” DCS Beverage Chiller is a deep, fully insulated compartment that can hold up to 17 gallons of ice to chill your refreshments. The Accessory, designed to house 1-liter bottles, can be installed at the front of your Beverage Chiller, freeing it up to be used as an outdoor sink.
SAFETY AND WARNINGS ! WARNING! Cut Hazard Failure to use caution could result in injury or cuts. • Take care - panel edges may be sharp. ! WARNING! Crush Hazard Failure to use caution could result in injury or WARNING cuts. • Closing drawers may cause injury to your hands or fingers. • Always close or open drawers using handles. Closing drawers may cause injury to your hands or fingers. Always close or open drawers using their handles.
PRODUCT DIMENSIONS B i j k C PLAN G f A E FRONT PRODUCT DIMENSIONS h D PROFILE BC1-25AC MODELS INCHES MM A Overall height 10 3/8 263 B Overall width 25 1/16 637 28 711 D Depth of beverage chiller chassis 21 1/16 535 E Width of beverage chiller chassis 24 1/8 613 9 13/16 249 9/16 14 H Depth from bottle holder to front of chiller 6 1/16 154 I Depth of lid 22 1/8 562 J Width of lid 26 5/16 669 K Height of lid 1 11/16 43 C Overall depth (beverage chiller + bottle hold
CUTOUT DIMENSIONS With bottle holder Ensure the base of the cavity is level, square and able to support the weight of the product when full. Any cabinet and/or ground preparation must be completed prior to installation and all support structures must be constructed of materials resistant to moisture damage.
CUTOUT DIMENSIONS Without bottle holder Ensure the base of the cavity is level, square and able to support the weight of the product when full. Any cabinet and/or ground preparation must be completed prior to installation and all support structures must be constructed of materials resistant to moisture damage. a b C CUTOUT DIMENSIONS BC1-25AC MODELS INCHES MM A Depth of cutout 21 1/16 535 B Width of cutout 24 3/16 615 9/16 15 C Min.
ATTACH THE BOTTLE HOLDER TO UNIT 8 1 Align the bottle holder onto the front of the Beverage Chiller. 2 Attach the bottle holder to the Beverage Chiller using the screws provided. 3 Fit the drip tray to the bottom of the holder.
SECURE PRODUCT INTO CUTOUT 1 Locate the mounting holes on each side of the beverage chiller and screw in the provided mounting clamps at the appropriate level for the counter-top. 2 Lower the chiller into the cutout, ensuring the drain outlet is accessible. 3 Secure the beverage chiller into place by tightening the clamping screws against the counter-top on all sides. The Beverage Chiller should be connected to a permanent waste drainage system. Connection: 1-1/2” NPS male thread.
FINAL CHECKLIST Read all installation instructions in this manual to see if the unit has been correctly installed. Ensure that installation has been completed correctly before use.
DCSAPPLIANCES.COM © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available. US CA 592077A 11.
