User guide

PROSTAR DCS COMPACT PROGRAMMING
TECHNICAL MANUAL PART 2 JANUARY 2002
MMC: 106 STATION SPEED DIAL NAME
DESCRIPTION:
Allows a character name to be entered for each personal speed dial location. This
name enables the speed dial number to be located when the directory dial feature
is used. The directory dial feature allows the display keyset user to select a speed
dial location by viewing its name. There are ten characters for Version 1 software.
There are 11 characters for Version 2 software.
Names are written using the keypad. Each press of a key selects a character.
Pressing the dial keypad moves the cursor to the next position. For example, if the
directory name is “SAM SMITH,” press the number “7” three times to get the letter
“S.” Press the number “2” once to get the letter “A.” Continue selecting characters
from the table below to complete your message. Pressing the bottom left
programmable key changes the letter from upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as the
previous character, press the UP key to move the cursor to the right.
DCS KEYSETS
COUNT 1 2 3 4 5
DIAL 0 Q Z . ) 0
DIAL 1 space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P R S & 7
DIAL 8 T U V
8
DIAL 9 W X Y ( 9
DIAL : = [ ]
The # key can be used for the following special characters: #, space, &, !, :, ?, ., %,
$, -, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;, \, " and ~.
HOME
PAGE
Table of
Contents