User guide

ManualsBrandsDCS Compact ManualsConsumer electronicsLCD 24B

261

262

263

264

265

266

267

268

269

270

PROSTAR DCS COMPACT PROGRAMMING

TECHNICAL MANUAL PART 2 NOVEMBER 1997

2.3.10

 MMC 119 CID DISPLAY This MMC is used by the end user to determine

which piece of Caller ID data is displayed when a

call rings at the user’s station.

 MMC 501 SYSTEM TIMERS This MMC has two new timers related to Caller ID.

The only timer that may need adjustment is the

CID DISPLAY TIME. This is the length of time that

CID data is displayed after the CID key is pressed.

 MMC 415 TRK. ABANDON This MMC is used by the technician to determine

which trunks will record data in the Call Abandon

list and print with an Abandon “A” flag on SMDR.

 MMC 608 CID BLOCK This MMC is used by the technician to assign CID

Review blocks to keysets to allow the user to

review CID data for previous calls.

 MMC 701 CLASS OF SERVICE All of the Caller ID features have been added to

this MMC to enable the technician to allow or

deny them.

 MMC 724 NUMBER PLAN The Caller ID features have been added to this

MMC to allow a technician to assign an access

code where necessary.

In addition to the above MMCs, it is necessary to have LCR programmed on the system

to enable certain features with a DIAL/REDIAL option to be used. This is because the

number format provided by the Central Office contains the area code. This area code

must be stripped off in the LCR modified digits section to allow a local number to be

correctly dialed.

For example, if the system is located in the 305 area code, the LCR digit table points

the entry 1305 to a modified digits entry that deletes the first four digits of the CID

number. Of course, this is a much simplified LCR scheme. As there are long distance

calls to be made within the home area code, additional entries are required to identify

these.

For example, if 1305-426 is a local call, the area code has to be stripped, but if 1305-

858 is long distance, the area code has to remain to allow the number to be dialed.

There are two ways of doing this. You can either enter all of the local office codes and

tell the system to strip the area code from them or you can enter the long distance

codes and tell them to ignore the modify digits entry.

A list of all of the local office codes can be found at the front of the local telephone

directory.

HOME

PAGE

Table of

Contents